How to change the hooks on you favorite, hot fishing lure.

Travel & Events

How to Change the Hooks on Your Favorite, Hot Fishing Lure

When it comes to fishing, the condition of your equipment can make all the difference in landing that big catch. Over time, hooks can become dull or damaged, affecting your success on the water. Here’s a detailed guide on how to change the hooks on your favorite, hot fishing lure using a mini bolt cutter, some black flux, and silver solder.

Step-by-Step Guide

  1. Cut the Split Ring:

    • Use a Knight Packs mini bolt cutter to cut the ring in two places. This will allow you to remove the old, damaged hook and split ring easily.

  2. Remove the Hook and Split Ring:

    • Once you've cut the ring, remove the old hook and the split ring.

  3. Open the Split Ring:

    • Open the split ring slightly to prepare it for the new hook. This can be done using a small pair of pliers.

  4. Attach the New Hook:

    • Place the new hook onto the opened split ring and then attach it back to the fishing lure.

  5. Close the Split Ring:

    • Using the pliers, close the split ring back up, ensuring it's aligned properly to secure the new hook in place.

  6. Apply Black Flux:

    • Dab a little black flux right where the solder is going to be applied. This helps in the soldering process by preventing oxidation.

  7. Prepare the Solder:

    • In this step, use Safety Silv 56 silver solder, which has a 1/32-inch diameter. A Map gas torch will be used to heat the area.

  8. Solder the Connection:

    • Apply the flame from the Map gas torch to the black flux until it starts to turn red. Then add the silver solder to create a strong, secure bond.

  9. Clean the Excess Flux:

    • After soldering, use a wire brush to clean off any excess flux residue. This will ensure the connection is clean and ready for use.

  10. Test and Ready for Fishing:

    • Finally, test the newly connected hook on your fishing lure. With everything secured, you're ready to cast your line and catch that big Yellow Tail!

Keywords

  • Knight Packs mini bolt cutter
  • Split ring
  • Fishing lure
  • Black flux
  • Silver solder
  • Safety Silv 56
  • Map gas torch
  • Wire brush
  • Hook replacement

FAQs

1. What tool is used to cut the split ring?
A mini bolt cutter from Knight Packs is used to cut the split ring in two places.

2. Why is black flux applied before soldering?
Black flux is applied to prevent oxidation during the soldering process, ensuring a clean and strong bond.

3. What type of solder is recommended for this process?
Safety Silv 56 silver solder, with a 1/32-inch diameter, is recommended for securely attaching the new hook.

4. Which gas is used for heating in this process?
Map gas is used to heat the area where the soldering takes place.

5. How do you clean the excess flux after soldering?
A wire brush is used to clean off any excess flux residue, ensuring the connection is smooth and clean.